All technical articles

Heating on board

Engine heat for heating and hot water

On Straycat, we use heat from our port-side engine, a Volvo Penta D2-60, to preheat the Webasto heating system and our Isotemp Basic water heater.

We installed an insulated B3-12-12 plate heat exchanger for this purpose. It transfers heat between the engine coolant circuit and the heating circuit without mixing the fluids in the two circuits.

The Webasto heating system has a circulation pump. It runs when we switch on the heating system and circulates heat through the heating circuit. It therefore does not automatically continue running after the engine has been stopped.

This allows us to make additional use of the heat generated during engine operation for heating and hot water. How much heat remains available afterwards depends on engine running time and temperatures in the system.

The installation photograph shows the insulated heat exchanger beside the water heater and the connected hoses.