All technical articles

SUNBEAMsystem

Sunbeam solar panels: our experience after six years

Our older Sunbeam panels on the Bimini were installed around six years ago after the purchase of Straycat. Their surfaces have since faded noticeably and show changes and damage in places. The photographs document their current condition.

We have regularly cleaned the panels using fresh water only. We suspect that prolonged UV exposure has contributed to their ageing. The exact cause has not yet been established.

Comparing the newer panels

Last year, we installed three further panels on the port side. Each panel in this comparison has its own MPPT controller.

At the time of the photograph, we had positioned the boat so that, according to our observation, all panels received equal sunlight. The Victron display showed the following readings:

Panel / controllerDaily yield up to the photographVoltageCurrentPower
Older Bimini panels
Aft, middle170 Wh16.76 V2.0 A34 W
Aft, starboard140 Wh16.09 V0.6 A10 W
Forward, starboard170 Wh16.59 V0.4 A7 W
Small Bimini panel0 Wh17.39 V0.0 A0 W
Newer port-side panels
Aft280 Wh15.81 V3.5 A55 W
Forward290 Wh17.54 V2.9 A51 W
Middle280 Wh16.43 V3.3 A55 W

How large is the difference?

The three larger older Bimini panels and the three newer port-side panels are SUNBEAMsystem Tough+ panels rated at 116 watts each, measuring approximately 106 × 54 centimetres. Both comparison groups therefore have a total rated output of 348 watts.

In this snapshot, the three larger older panels produced 51 watts in total, averaging 17 watts per panel. The three newer panels produced 161 watts in total, averaging 53.67 watts per panel.

The average output of the equally sized older panels was therefore 68.3 percent lower than that of the newer group. The displayed output represented approximately 14.7 percent of rated output for the older group and 46.3 percent for the newer group.

The smaller Bimini panel remains in the table with its displayed readings. Because it is a different size, it is excluded from this comparison.

This snapshot shows a substantial difference in output. However, it is not a long-term measurement and cannot, on its own, establish how much of the difference is caused by ageing, the panels themselves or other factors.

Durability and performance: disappointing for us

At a price of around €550 to almost €700 per panel, I expect reliable performance over the long term. Our installed older Sunbeam panels cost almost €3,000 including installation. That makes their current condition and the difference in output documented above particularly disappointing to me after around six years.

For us, the purchase cost and durability so far do not add up. The same amount could buy several cheaper panels or pay for replacements later on. We cannot say whether those would last longer. However, at this price level, we would have expected the panels to be in considerably better condition after six years, both in appearance and in performance.